Extreme Networks ExtremeWireless AP3000X Installation Manual page 32

Install the Access Point on a Beam
•
Beam attachment area is at least 0.5 in. (12.7mm) wide and as long as the access
point's largest dimension.
•
Beam mounting surface is at least 0.040 in. (1.0 mm) thick, but less than 0.650 in.
(16.5mm) thick.
About This Task
If you are installing the access point in a warehouse or other industrial environments,
then you might have to install the AP on a beam instead of a ceiling.
Procedure
1. Align the red dot on the access point with the red dot on the accessory bracket.
2. Insert the plastic part posts into the access point back recess.
3. Push the access point onto the plastic part, and rotate the access point about one-
sixth turn clockwise to make it lock in place.
4. Plug the RJ45 connector plug into ETH or ETH0, RJ45 connector receptacle on the
access point.
If desired, flat Ethernet cables and caps may be used with all indoor access points.
5. Open the top screw as necessary and place the beam clip onto a beam.
Figure 14: ACC-BKT-AX-BEAM accessory bracket
32 ExtremeWireless™ AP3000X Access Point Installation Guide
Note
If you can turn or twist the access point, it was not locked in place properly.
Remove the access point and attach it again until it locks in place.
Note
You must hold the access point when attaching the beam clip.
Access Point Installation