Install The Access Point On A Beam - Extreme Networks ExtremeWireless AP3000X Installation Manual

Access Point Installation
Figure 13: ACC-BKT-AX-JB accessory bracket plastic part
Procedure
1. Align the red dot on the back of the access point against the red dot on the plastic
part.
2. Push the access point onto the plastic part and turn it clockwise until you hear it
lock in place.
3. Insert the RJ45 cable connector to the Ethernet connector on the access point.

Install the Access Point on a Beam

Before You Begin
You need the following items:
•
AP3000X
•
ACC-BKT-AX-BEAM mounting bracket
Find a location that supports the following requirements:
•
The beam must be able to support the access point in all environmental conditions.
•
The beam must be flat.
ExtremeWireless™ AP3000X Access Point Installation Guide
Install the Access Point on a Beam
31