Table of Contents
Advertisement
Access Point Installation
2. Bring the LAN cable from the wall through the bracket hole.
Align the cable before attaching the bracket to the wall.
3. Attach the wall bracket to the wall using three M3.5 screws and three screw-in
anchors.
4. Align the access point red dot against the three red dots on the -WL bracket.
5. Press and rotate the access point clockwise about one-sixth turn until it locks into
place on the bracket.
6. Attach the network cable.
Install the Access Point on a Junction Box
Before You Begin
You need the following items:
•
AP3000X
•
ACC-BKT-AX-JB for junction box mounting.
About This Task
Install a access point to a junction box if you want to power the AP using an electrical
connection.
The ACC-BKT-AX-JB accessory bracket is used when you need to install the access point
on an indoor junction box. The ACC-BKT-AX-JB access has two parts:
•
A metal part that attaches to the junction box (also called the sheet-metal junction
box hole plate)
Note
A standard Ethernet cable can be used if you do not mind the cable being
visible. To hide the Ethernet cable, a flat cable and a cable cap is required.
ExtremeWireless™ AP3000X Access Point Installation Guide
Install the Access Point on a Junction Box
29
Advertisement
Table of Contents
