Table of Contents
Advertisement
Supported Power Accessories
Table 12: Supported brackets (continued)
Accessory
AH-ACC-BKT-AX-SL
AH-ACC-BKT-AX-WL
ACC-BKT-TB-NF
AH-ACC-BKT-916-KIT
ACC-BKT-AX-TBW
ACC-BKT-AX-BEAM
ACC-BKT-AX-JB
Supported Power Accessories
You can power the access point through the ETH0 RJ45 Ethernet port. But if you need
to power the AP with an external power supply, you can purchase a 12V DC power
supply.
There is no wall mount bracket for the 12VDC power supply.
Table 13: Power accessories
Part number
37215
Other Accessories
The following table shows the additional accessories available for your access point.
Table 14: Accessories
Part number
ACC-WIFI-MICRO-USB
16
ExtremeWireless™ AP3000X Access Point Installation Guide
Description
Mounting bracket for Silhouette ceilings (ceiling grid with 1/8 in. or
1/4 in. bottom opening).
Mounting bracket for direct-to-wall installations when a 1.25
inches of space is desired between the wall and the access point.
Mounting bracket for 15/16 in. wide T-bars with sculpted ceiling
tiles.
Mounting bracket for 9/16 in. wide T-bars with sculpted ceiling
tiles.
Mounting bracket for 1.5 in. wide T-bars.
Mounting bracket for beam mounting.
Mounting bracket for junction box or wall mounting.
Description
PWR 12 VDC, 2A (24W), 2.5 mm X 5.5 mm
connector
Description
Extreme Networks micro USB cable.
Note: When you connect to the device using
the micro USB Console port, the management
station from which you connect to the device
must have a VT100 emulation program, such
as TeraTerm Pro (a free terminal emulator) or
Hilgraeve HyperTerminal. Set your baud rate to
115200.
AP3000X Overview
Advertisement
Table of Contents
