Table of Contents
Advertisement
Access Point Installation
Lock Your Access Point
Before You Begin
You will need the following items:
•
A 3 mm diameter security cable
•
A lock to secure the cable
About This Task
You can use the Kensington security slot to secure your access point. The security
feature prevents someone from taking the AP.
Procedure
1. Insert a Kensington lock into the security slot in the access point.
2. Insert a 3mm diameter safety cable into the lock.
3. Secure the cable to the device and another permanent item.
Post Installation
After you have installed the access point, you should do the following tasks:
•
Confirm that the LED is white. A white LED indicates that your AP has powered up
and registered with the controller. An amber light indicates a technical issue that
requires a resolution. See
You can see a list of registered APs and the status of each AP in the controller.
•
Wireless APs are added to your network with the default settings. After the AP
registers with a controller, you should configure the AP to meet your needs and
assign it to one or more Virtual Network Services (VNS). You can also modify the
settings for each radio on the AP.
Each AP has a tab in the controller where you can find the settings and
configurations. You can configure both individual APs or a group of APs.
LED Status
on page 13 for an explanation of the LED states.
ExtremeWireless™ AP3000X Access Point Installation Guide
Lock Your Access Point
35
Advertisement
Table of Contents
