Extended Trigger Configuration - HP 8163A Programming Manual

command: :TRIGger
syntax: :TRIGger<wsp>NODEA|1|NODEB|2
description: Generates a hardware trigger.
parameters: 1 or NODEA:
2 or NODEB:
Use ":TRIGger:CONFiguration:EXTended" on page 129 to configure Node
A and Node B.
NOT E
response: none
example:
trig 1
command: :TRIGger:CONFiguration:EXTended
syntax: :TRIGger:CONFiguration:EXTended<wsp><Node A Input Config.>,
<Node B Input Config.>,<Output Matrix Config.>
description: Sets the extended hardware trigger configuration.
parameters: Node A Input Configuration:
Node B Input Configuration:
Output Matrix Configuration:
response: none
example:
trig:conf:ext 0,0,0
Introduction to Programming
Triggering - The TRIGger Subsystem
Extended Trigger Configuration
This section includes information for advanced users about how to
customize your use of the trigger system.
You can configure the ouputs and inputs from two nodes, Node A
and Node B. See Figure 4-1 on page 131 for more information on
Node A and Node B. You can configure these nodes to be triggered
by certain events and for these nodes to trigger particular actions.
":TRIGger" on page 122 describes the :TRIGger command for
basic users.
129
Generates trigger at Node A.
Generates trigger at Node B.
A 32-bit unsigned integer, see below.
A 32-bit unsigned integer, see below.
A 32-bit unsigned integer, see below.