HP 8163A Programming Manual page 94

command: :OUTPut[n][:CHANnel[n]]:PATH
syntax: :OUTPut[n][:CHANnel[n]]:PATH<wsp><path>
description: Sets the regulated path.
parameters: HIGHpower:
LOWSse:
BHRegulated:
BLRegulated:
response: none
example:
output1:path high
affects: All instruments
command: :OUTPut[n][:CHANnel[n]]:PATH?
syntax: :OUTPut[n][:CHANnel[n]]:PATH?
description: Returns the regulated path.
parameters: none
response: HIGHpower:
LOWSse:
BHRegulated:
BLRegulated:
example:
output1:path?
affects: All instruments
Introduction to Programming
Signal Generation – The SOURce Subsystem
→
HIGH<END>
94
The High Power output is regulated.
The Low SSE output is regulated.
Both outputs are active but only the High
Power output is Regulated.
Both outputs are active but only the Low
SSE output is Regulated.