HP 8163A Programming Manual page 119

command: [:SOURce[n]][:CHANnel[n]]:WAVelength:SWEep:STOP
syntax: [:SOURce[n]][:CHANnel[n]]:WAVelength:SWEep:STOP<wsp>
<stop value>[PM|NM|UM|MM|M]
description: Sets the end point of the sweep.
parameters: The wavelength at which the sweep ends as a float value in meters.
If you specify no units in your command, meters are used as the default.
response:
none
example:
wav:swe:stop 1550nm
affects: All Tunable Laser modules
command: [:SOURce[n]][:CHANnel[n]]:WAVelength:SWEep:STOP?
syntax: [:SOURce[n]][:CHANnel[n]]:WAVelength:SWEep:STOP?
description: Returns the end point of the sweep.
parameters: none
response: The wavelength at which the sweep ends as a float value in meters.
example:
wav:swe:stop?
affects: All Tunable Laser modules
command: [:SOURce[n]][:CHANnel[n]]:WAVelength:SWEep:[STATe]
syntax: [:SOURce[n]][:CHANnel[n]]:WAVelength:SWEep:[STATe]<wsp>
STOP|0|STARt|1|PAUSe|2|CONTinue|3
description: Stops, starts, pauses or continues a wavelength sweep.
parameters: 0 or STOP:
1 or STARt:
2 or PAUSe:
3 or CONTinue:
response: none
example:
wav:swe STOP
affects: All Tunable Laser modules
Introduction to Programming
Signal Generation – The SOURce Subsystem
→
+1.55000000E-006<END>
Stop the sweep.
Start a sweep.
Pause the sweep.
Continue a sweep.
119