HP 8163A Programming Manual page 121

command: [:SOURce[n]][:CHANnel[n]]:WAVelength:SWEep:STEP:
[WIDTh]
syntax: [:SOURce[n]][:CHANnel[n]]:WAVelength:SWEep:STEP:[WIDTh]
<wsp><value>[PM|NM|UM|MM|M]
description: Sets the width of the sweep step
parameters: The width of the sweep step as a float value.
If you specify no units in your command, meters are used as the default.
response: none
example:
wav:swe:step 5nm
affects: All Tunable Laser modules
command: [:SOURce[n]][:CHANnel[n]]:WAVelength:SWEep:STEP:
[WIDTh]?
syntax: [:SOURce[n]][:CHANnel[n]]:WAVelength:SWEep:STEP:[WIDTh]?
description: Returns the width of the sweep step
parameters: none
response: The sweep step as a float value in meters.
example:
wav:swe:step?
affects: All Tunable Laser modules
Introduction to Programming
Signal Generation – The SOURce Subsystem
→
+5.00000000E-009<END>
121