HP 8163A Programming Manual page 124

command: :TRIGger[n][:CHANnel[n]]:INPut?
syntax: :TRIGger[n][:CHANnel[n]]:INPut?
description: Returns the incoming trigger response.
parameters: none
response: IGNore:
SMEasure:
CMEasure:
NEXTstep:
SWStart:
example:
trig1:inp?
Introduction to Programming
Triggering - The TRIGger Subsystem
Ignore incoming trigger.
Start a single measurement. If a measurement
function is active, see
":SENSe[n][:CHANnel[n]]:FUNCtion:STATe" on
page 83, one sample is performed and the result is
stored in the data array, see
":SENSe[n][:CHANnel[n]]:FUNCtion:RESult?" on
page 83.
Start a complete measurement. If a measurement
function is active, see
":SENSe[n][:CHANnel[n]]:FUNCtion:STATe" on
page 83, a complete measurement function is
performed.
Perform next step of a stepped sweep.
Start a sweep.
→
ign<END>
124