Figure 1-1
Introduction to Programming
HP-IB Interface
• You can set the HP-IB address by using the command
":SYSTem:COMMunicate:GPIB[:SELF]:ADDRess" on
page 68.
• You can set the HP-IB address from the front panel. See your
instrument's User's Guide for more information.
The default HP-IB address is 20.
Returning the Instrument to Local Control
If the instrument is in remote control, a screen resembling
Figure 1-1 will appear. Press [Local] if you wish to return the
instrument to local control.
Remote Control
19