How To Use The System Protection Tool - Datalogic UniQ 1150-1X41 Product Reference Manual

How to use the System Protection tool

The System Protection tool GUI can be opened:
• By clicking on the notification popup
• By right-clicking the tray-bar icon then, "Configure"
• Double-clicking the tray-bar icon
• From Start Menu\Datalogic\System Protection
Enable the system protection
NOTE: When the System Protection is enabled any change or deletion on
the C:\ drive will be restored after system reboot.
• Open the System Protection tool GUI
• Click the ENABLE button
• A message advise the User to confirm the new setting. Press YES to enable System
Protection
• A message advise the User that the system will be rebooted. Press YES to continue
SYSTEM PROTECTION
PRODUCT REFERENCE GUIDE
49