Installation Environment; Fume / Dust Extractor - Datalogic UniQ 1150-1X41 Product Reference Manual

INSTALLATION ENVIRONMENT

The laser marker must be installed in a suitable environment in order to allow proper air
flow and correct housing of the cables.
The laser marker uses a forced air cooling system: an adequate air flow is necessary to
guarantee its correct cooling. Install the laser marker so that air flow is not obstructed.
Moreover, do not install it near a heat source.
Clean the main fan and the cover when they are dirty. If the main fan and the cover are
dirty, insufficient air-flow might not ensure correct cooling and might stop the marking
operation. Clean the main fan and the cover periodically.

FUME / DUST EXTRACTOR

During the marking process, dust and/or fume may be produced. It is important to use
an adequate fume/dust extractor and/or air filtration (see "Fume Extractor" on
page 65).
CAUTION: If not enough space is provided, the temperature inside the laser
marker could rise, causing temperature error.
Figure 5: Installation environment
CAUTION: Marking PVC (or other plastic material) can cause the release of
chlorine gas which can be harmful to the laser operator and to the laser
marker itself. Always use adequate fume extractor during PVC and plastic
marking.
≥200mm
INSTALLATION ENVIRONMENT
PRODUCT REFERENCE GUIDE
15