SET UP
Remote Mode Control connection
To use the laser marker in "Remote Mode Control" it is necessary to connect a network
cable:
F-THETA SCAN LENS PROTECTION CAP REMOVAL
Remove the F-Theta scan lens protection cap before marking operation:
42
UNIQ™
Figure 35: Connecting LAN port
NOTE: The LAN port is configured by default with a fixed IP Address and
Subnet Mask:
- LAN 1 Default IP address: 192.168.1.10
- Default Subnet Mask: 255.255.255.0
See "Change the LAN configuration and IP address" on page 55 in order to
change LAN configuration.
NOTE: Ethernet TCP/IP 10, 100 Mbit.
Figure 36: F-Theta scan lens protection cap removal
CAUTION: Marking with the lens protection cap in place could result in
damage to the laser marker.