How To Test And Mark Layout - Datalogic UniQ 1150-1X41 Product Reference Manual

HOW TO TEST AND MARK LAYOUT

In "STANDBY SHUTTER CLOSED" state, press Limits All button in the Laser Toolbar to
adjust the object position in the marking field:
X1 - COMMAND
BOX SIGNAL
EXT_ENABLE_A
EXT_ENABLE_B
STATE
EXT_KEY ON
OFF
OFF
Limits function: displays the
bounding box of the object(s)
present in the document. Mar-
gins are displayed using a red
laser pointer
CAUTION: Marking highly reflective materials might cause optical feedback
into laser marker. This may result into irreversible damage of the optical
components of laser marker.
Verify that the position and geometry of the object to mark does not cause
any reflection into the optical aperture of the laser marker F-Theta scan
lens.
Please contact our Customer Support Service for support on your particu-
lar application.
Optical induced damage caused to laser marker by back reflection from
high reflective materials is not covered by warranty.
HOW TO TEST AND MARK LAYOUT
PRODUCT REFERENCE GUIDE
95