Announcement Service-Pri - NEC NEAX 2400 IPX Programming Manual

ANNOUNCEMENT SERVICE-PRI

A-92 ANNOUNCEMENT SERVICE-PRI
1. General Description
This feature allows a user from the ISDN trunk to hear a prearranged announcement when the user dials a
predetermined access code.
This feature requires an announcement machine or a Digital Announcement Trunk (DAT).
Note:
2. Operating Procedure
1. The system receives the announcement trunk access code.
(a) If a multiple connection is made, the announcement is repeatedly sent out.
(b) If a single connection is made, the announcement is sent out only once and then the announcement
trunk is released. If the system data specifies "Ringback Tone is to be sent", Ringback Tone is returned
to the caller after the announcement finishes.
2. The office data is checked for the following.
(a) Multiple or single connection.
(b) 30-second forced disconnection.
(c) Ringback Tone to be sent or not to be sent after the announcement finishes.
(d) Remote office answer signal sending to be sent or not to be sent.
3. The call is connected to the Announcement Trunk, and the caller hears the announcement.
4. If 30-sec. forced disconnection is specified, the Announcement Trunk is released 30 seconds after the call
has been connected to the Announcement Trunk, and the caller receives the Busy Tone. Otherwise, the call
remains connected to the Announcement Trunk until the caller hangs up.
3. Programming
STEP 1: Assign the Basic Data for ISDN (Refer to
STEP 2: Assign the announcement data (Refer to "[A-15] ANNOUNCEMENT SERVICE" in Feature
Programming Manual.)
CHAPTER 5
Page 34
Revision 1.0
Chapter 3, "Basic Data Assignment for
NDA-24305
ISDN").