Getting Started; Software Installation Procedure; Installing; Verifying The J-Link Driver - Analog Devices EVAL-ADuCM342EBZ User Manual

User Guide

GETTING STARTED

SOFTWARE INSTALLATION PROCEDURE

Items required to get started are as follows:
Keil µVision v5 or higher
►
CMSIS pack for ADuCM342
►
Segger debugger interface driver and utilities
►
Complete the steps described in this section before plugging any of
the USB devices into the PC.
Support files for Keil are provided at the ADuCM342 Design Tools
page. For Keil v5 upwards, CMSIS pack is required and is available
on the ADuCM342 product pages.

INSTALLING

To install the software, do the following steps:
1. Close all open applications.
2. From the Keil website, download and install the Keil µVision v5
(or higher).
3. From the Segger website, download and install the latest J-
Link software & documentation pack for Windows.
4. From the ADuCM342 product page, download the CMSIS pack
for the ADuCM342.

VERIFYING THE J-LINK DRIVER

To install the J-Link driver, do the following steps:
1. Follow the sequence of instructions provided by Segger to
download and install the J-Link driver.
2. When the software installation is complete, plug the debug-
ger/programmer into the USB port of your PC using the USB
cable supplied.
3. Verify that the emulator board appears in the Windows
Manager window (see Figure
analog.com
®
Device
2).
EVAL-ADuCM342
Figure 2. Device Manager
Rev. 0 | 4 of 9