Getting Started; Software Installation Procedure; Installing; Verifying The J-Link Driver - Analog Devices EVAL-ADUCM331QSPZ User Manual

EVAL-ADUCM331QSPZ User Guide

GETTING STARTED

SOFTWARE INSTALLATION PROCEDURE

Items required to get started are as follows:

Keil μVision v5 or higher

CMSIS pack for ADuCM330/ADuCM331

Segger debugger interface driver and utilities
Complete the steps described in this section before plugging
any of the USB devices into the PC.
Support files for Keil are provided at the
Tools page. For Keil v5 upwards, CMSIS packs are required and
are available on the ADuCM330/ADuCM331

INSTALLING

To install the software, take the following steps:
1. Close all open applications.
2. Download and install Keil μVision v5 (or higher) from the
Keil website.
3. From the Segger website, download and install the latest
J-Link software & documentation pack for Windows.
4. From the ADuCM330/ADuCM331
the CMSIS pack for the ADuCM330/ADuCM331.
ADuCM33x Design
product pages.
product page, download
Rev. 0 | Page 3 of 6

VERIFYING THE J-LINK DRIVER

Installing the J-Link driver is a three-step process.
1. Follow the sequence of instructions provided by Segger to
download and install the J-Link driver.
2. When the software installation is complete, plug the
debugger/programmer into the USB port of your PC using
the USB cable supplied.
3. Verify that the emulator board appears in the Windows®
Device Manager window (see Figure 2).
Figure 2. Device Manager
UG-718