Fixing Assembly Inlet Solenoid Assembly - Canon GP335 Service Manual

CHAPTER 9 FIXING SYSTEM
C. Fixing Assembly Inlet
Solenoid Assembly
1) Remove the following:
• Drum unit
• Rear cover
• Flywheel
• Composite power supply unit
• DC controller unit
2) Remove the harness, and remove the two
screws [1]; then, detach the harness guide
[2].
[3]
[2]
Figure 9-237
3) Remove the three screws [3], and remove
the fixing assembly inlet solenoid
assembly [4].
[6]
Figure 9-238
9-28
[1]
[1]
[5] [4]
[4]
COPYRIGHT © 1999 CANON INC. CANON 405/335 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
Caution:
The fixing assembly inlet guide solenoid
assembly is adjusted at the factory. Do
not remove the solenoid, i.e., do not
loosen the screw [6].