Canon GP335 Service Manual page 478

CHAPTER 14 TROUBLESHOOTING
5 E005 (The fixing cleaning belt has run out.)
Cause
Fixing cleaning
belt
Counter
DC controller
PCB
Note: You can enable or disable the belt replacement message appearing on the User screen in
service mode (OPTION>USER>WEB-DISP); at time of shipment, the message is disabled.
14-60
Step
1 Is the fixing cleaning belt taken up?
2 Was the counter reading cleared
when the cleaning belt was
replaced last time?
(COPIER>COUNTER>MISC>FIX-
WEB in service mode)
COPYRIGHT © 1999 CANON INC. CANON 405/335 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
Check Yes/No Action
YES Replace the cleaning
belt.
NO Clear the counter. (Keep
this in mind when
replacing the cleaning
belt next time; see note.)
YES Replace the DC
controller PCB.