Canon GP335 Service Manual page 266

CHAPTER 8 PAPER DECK
4) Remove the front cover of the deck. (See
p.8-21.)
5) Remove the four screws [3], and detach
the roll support plate [4].
[4]
Figure 8-330
6) Remove the coupling shaft [5] and the E-
ring [6]; then, detach the pulley cover [7].
7) Remove the two screws [8] and the cable
fixing plate [9]; then, detach the lifter
cable [10] on the outside.
8) Remove the two screws [11] and the cable
fixing plate [12] on the right side; then,
detach the lifiter cable [13] on the inside.
9) To detach the lifiter cable [13] from the
pulley [14] on the inside, remove the two
set screws 1 [16] of the pulley [15] on the
outside, and detach the pulley [15] on the
outside.
8-32
[3]
COPYRIGHT © 1999 CANON INC. CANON 405/335 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
[16] [10]
[14] [15]
[8] [9]
Figure 8-331
[13]
[12] [11]
[7]
[6]
[5]