Canon GP335 Service Manual page 395

Hide thumbs Also See for GP335:

Checking the Operation

1) Connect the connector [1] of the Power

Supply-A1 to the connector [2] of the

copy data controller correctly as shown.

Check to make sure that the cord is in the

groove of the board.

Groove in the board

Figure 12-509

2) Connect the Power Supply-A1 to the

power plug, and check to make sure that

LED1 of the copy data controller turns on.

Figure 12-510

CHAPTER 12 INSTALLATION

3) Turn on the copier's main switch, and

check to make sure that LED2 of the copy

data controller flashes.

Make one copy to make sure that LED3

flashes during the copying run.

Figure 12-511

4) If you are connecting a Communication

Control board-A1 or an Interface Board-

B1 (i.e., requiring a Power Supply-A1),

go to step 5).

Turn on the copier's main switch, and

check to make sure that LED 1 of the copy

data controller turns on and LED2 flashes.

Make one copy to make sure that LED3

flashes during the copying run.

Figure 12-512

Chapters

Gp405 Gp405sm