DAQ system PCIe-FRM24 C User Manual page 32

(2) Board # selection
It can select a Board #0 ~ Board #3. (Selection J2)
(3) "Get Ver."
It shows the version of FPGA and Firmware.
(4) "Device Init" button
Press this button to initialize the function of receiving image frame data. It is performed only
once after power is applied to the board.
(5) "Start/Stop" button
Press this button to begin to save image data.
(6) FRAME View
Press this button to read the image frame data of the board to your PC. If image frame
data is not saved on the board, you must wait until the end of data collection.
Auto View" : If checked, it shows continuously.
(7) "Frame Read."
Read image frame saved in board to PC (Hexa value) as below figure. If the image frame is
not saved to the board, wait until the save is completed..
PCIE-FRM24_C User's Manual
31