Table of Contents
Advertisement
SNOW KIT INSTRUCTIONS
The snow brush and snow scraper kits help keep ice and
snow buildup at a minimum along the drive rail of the
SlideDriver II gate operators.
Note: The snow brush and snow scraper kits can be
ordered together or separately. These instructions
explain the installation process for both.
PARTS
●
Snow brushes and/or snow scrapers
HARDWARE
●
1/4-20 x 3/4 hex head cap screw
●
1/4 in fl at washer
●
1/4-20 lock nut
●
8-32 x 1/2 self-tapping screw
TOOLS
●
Phillips-head screwdriver
●
Wrench
INSTALL THE SNOW BRUSHES
1. Loosen the screws that secure the cover to the
SlideDriver II chassis and remove the cover.
2. Set the power switch to OFF.
3. Slide the snow brushes into place and secure them
using the fasteners provided. The aluminum fl ange
should be inside the operator (Figure 3 and Figure 6).
4. Set the power switch to ON.
5. Test the gate operator.
6. Carefully replace the cover and secure it to the
chassis.
Loosen
cover
screws
Figure 1. Remove the Cover
APPENDIX B - ACCESSORY INSTRUCTIONS
SLIDEDRIVER II SNOW BRUSH AND SCRAPER
Lift
cover
Figure 2. Set Power Switch to OFF
Lock nut Washer Snow brush Chassis Washer Screw
Inside of
Operator
Figure 3. Fasten Snow Brushes
D1155 Rev. A ©2022
Power
Switch
1
MX5386 Rev. B ©2023
111
Advertisement
Table of Contents
