Table of Contents
Advertisement
INSTALL THE OPERATOR
INSTALL THE CHASSIS
WARNING
Obtain help before lifting or moving the operator.
SlideDriver II models can weigh over 260 lbs (118
kg). Failure to comply may result in serious injury to
personnel, damage to the equipment, or both.
1. Align the operator. Locate rear panel 1½ in from the
face of vertical uprights.
2. Install concrete anchors (½ x 4 in min.). 2 anchor
bolts required per cross support. 3 anchor bolts
required per cross support for heavy gates (SD80V
and SD200V).
3. Tighten the nuts, but leave room for adjustments.
4. Level the operator. Shim with a corrosion resistant
material such as aluminum or plastic.
CAUTION
Do NOT fully tighten the anchor bolts until after the
drive rail is installed.
20
support.hysecurity.com
Rear panel
Anchor bolts
(½ x 4 in, min.)
Minimum 4
anchor bolts
(6 bolts required
for heavy gates
80V and 9 bolts
required for
200V operators.)
Base Riser Installation and Dimensions
Option:
SlideDriver II Base Riser (most models)
Inches: 26W x 12H x 14½D
Millimeters: 660W x 300H x 368D
Option:
SlideDriver II Base Riser (200 series)
Same H & D
47 in W (1090 mm)
Level
Side view
Advertisement
Table of Contents
