Advanced Display Module (Adm) Operation - Graco EVR Instructions Manual

Advanced Display Module (ADM) Operation

When main power is turned on by turning the Power
Disconnect Switch (C) to the ON position, the splash
screen will be displayed until communication and initial-
ization is complete.
To begin using the ADM, the machine must be on and
enabled. To verify the machine is enabled, verify the
System Status Indicator Light (AB) is illuminated green,
see F . 3 on page 9. If the System Status Indicator
IG
Light is not green, press the ADM Power On/Off (AA)
button . The System Status Indicator Light will illu-
minate yellow if the machine is disabled.
Perform the following tasks to fully setup your system.
1. Set general system settings. See Setup Screen 4,
page 38.
2. Set units of measure. See Setup Screen 1,
page 37.
3. Enable/disable system features. See Setup Screen
2, page 37.
4. Define pump information. See Setup Screen 1,
page 37.
5. Define shots. See Recipe Definition Screen 1,
page 36.
6. Define recipes. See Recipe Definition Screen 2,
page 36.
7. If desired, view/reset counters. See Maintenance
Screen 1, page 41.
3A8565C
Advanced Display Module (ADM) Operation
8. Enable/disable integration features. See Integra-
tion Screen 1, page 43.
31