Graco HYDRA-SPRAY EH 433 GT Instructions-Parts List Manual

INSTRUCTIONS-PA.RTS LIST 387-1 11
R e v "I
"
4-111
This manual contains IMPORTANT
WARNINGS and INSTRUCTIONS
READ AND RETAIN FOR REFERENCE
ELECTRIC-HYDRAULIC "AIRLESS" PAINT SPRAYER
~~~~~ ~
EH 433 GT HYDRA-SPRAY"
28w
PSI (197 bar) MAXIMUM WORKING PRESSURE
Provides 1 GPM
at
loo0 PSI (70 bar)
With
60
Hz Motor and Suction Tube Assembly
Model 226-433 Series " K
Model 217-433
With 60 Hz Motor and Suction Tube Assy.
With
50 Hz Motor and Immersion Supply Tube
Model 226-432 Series "J"
ORAC0
SUPERSEDES 7-7?
-
" . I
0
Compact design-can be loaded into station wagon
0
Sealed sump comes with 1 gallon of hydrauh fluid,
by laying unit on its back.
has vent valve, dipstick level gauge and fill~po-t with
0
Needs no air compressor-uses 115 or 230 volt
filter.
electric service. See page
3.
0
Hydraulic pump intake and hydraulic fluid'system
return have filter.
0
Has 2-stage power system that develops high paint
breakup pressure. Electric motor-hydraulic pump
0
Hydra-Spray pump is divorced design. Paint pump
(stage 1); hydraulic motor-paint pump (stage
2).
displacement rod, nitralloy cylinder sleeve and
has covered wet-cup packing lubricator, nitralloy
0
Has up-through air cooling systemforelectricmotor chrome alloy ball check valves with tungsten-
and hydraulic fluid. carbide seats.
0
Capacitor start electric motor
has thermal protection
with automatic reset, is UL listed and fan cooled
0
Hydra-Spray pump outlet has a high pressure filter
with explosion-proof ON-OFF switch.
and system pressure drain valve.
0
TECHNICAL DATA on page 11-ACCESSORIES
0
Variablevolumehydraulicvanepumprunsatneutral- on back page.
idle when you close spray gun-adjusts to set
gun.
operating pressure and volume when you open
GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440
@COPYRIGHT 1973 GRACO INC.