Graco EVR Instructions Manual page 12

Installation
F . 7: Terminal Connections
IG
3. Insert the power cord through the cord grip (strain
relief) 3/4-14 NPT male, cable range 0.35-0.63 in.
(8.9-16 mm), and into the EVR Frame (S).
4. Attach the ground wire to the ground terminal
inside the EVR Frame (S) as shown in F
F . 8: Attach Ground Wire
IG
5. Refer to F . 7 and connect the wires from the
IG
power cord into terminals 1L1 and 3L2.
NOTE: Do not attach the ground wire to the grounding
lug locknut on the outside of the electric driver. See
Grounding on page 11.
12
6. Place the power wires into the open area on either
T
7. Reinstall the EVR Frame Cover (T) and Power Dis-
8. Tighten the cord grip to securely hold the power
Z
. 8.
IG F
IG
S
side of the Power Disconnect Switch (C) as space
permits.
connect Switch (C) using the four screws removed
in step 2.
cord in the EVR Frame (S).
. 9: Tighten Cord Grip
3A8565C