Emerson Micro Motion 2400S Configuration And Use Manual page 74

Optional Configuration
Some alarms can be reclassified. For example:
• The default severity level for Alarm A020 (calibration factors unentered) is
reconfigure it to either
• The default severity level for Alarm A102 (drive over-range) is
reconfigure it to either
For a list of all status alarms and default severity levels, see Table 8-8. (For more information on
status alarms, including possible causes and troubleshooting suggestions, see Table 11-2.)
To configure alarm severity:
• Using ProLink II, see Figure B-3.
• Using a DeviceNet tool, refer to Table C-7 and:
a. Set the alarm index (Attribute 18).
b. Set the severity for that alarm (Attribute 19).
Note: This functionality is not available via the display menus.
Table 8-8 Status alarms and severity levels
Alarm code ProLink II message
A001 (E)EPROM Checksum Error (CP)
A002 RAM Error (CP)
A003 Sensor Failure
A004 Temperature Sensor Failure
A005 Input Overrange
A006 Not Configured
A008 Density Overrange
A009 Transmitter Initializing/Warming Up
A010 Calibration Failure
A011 Zero Too Low
A012 Zero Too High
A013 Zero Too Noisy
A014 Transmitter Failed
A016 Line RTD Temperature Out-of-Range
A017 Meter RTD Temperature Out-of-Range
A020 Calibration Factors Unentered (FlowCal)
A021 Incorrect Sensor Type (K1)
A029 PIC/Daughterboard Communication Failure Fault
A030 Incorrect Board Type
A031 Low Power
A032 Meter Verification/Outputs In Fault
A033 Sensor OK, Tubes Stopped by Process
A102 Drive Overrange/Partially Full Tube
A104 Calibration in Progress
A105 Slug Flow
A107 Power Reset Occurred
66
or
Informational Ignore
or .
Ignore Fault
Default
severity
Fault
Fault
Fault
Fault
Fault
Fault
Fault
Ignore
Fault
Fault
Fault
Fault
Fault
Fault
Fault
Fault
Fault
Fault
Fault
Fault
Fault
Info
Info
Info
Info
.
Informational
Configurable?
No
No
Yes
No
Yes
Yes
Yes
Yes
No
Yes
Yes
Yes
No
Yes
Yes
Yes
No
No
No
No
No
Yes
Yes
(1)
Yes
Yes
Yes
®
Micro Motion Model 2400S Transmitters for DeviceNet
Fault , but you can
, but you can
Affected by
fault timeout?
No
No
Yes
Yes
Yes
No
Yes
No
No
No
No
No
No
Yes
Yes
No
No
No
No
No
No
Yes
No
No
No
No
™