R&S Nrpm Tour; R&S Nrpm3 Sensor Module - Rohde & Schwarz R&S NRPM User Manual

®
R&S NRPM
3.3 R&S NRPM Tour
The following chapters introduce the main hardware components of the R&S NRPM
OTA power measurement solution.
3.3.1 R&S NRPM3 Sensor Module
This chapter provides an overview of the available connectors and LED of the
R&S NRPM3.
Figure 3-1: The R&S NRPM3 sensor module
1 = Antenna connector
2 = Host interface connector
3 = Trigger I/O connector
4 = Status LED
Antenna connector (1)
Multipole antenna connector for connecting the
●
R&S NRPM3 to the interface module R&S NRPM-Z3.
●
R&S NRPM3 to the filtered cable feedthrough module R&S NRPM-ZD3 with the
interface cable R&S NRPM-ZKD3.
Host interface connector (2)
The host interface connector is used for establishing a connection between the sensor
module and the USB host. Use either the R&S NRP-ZKU or the NRP-ZK6 cable for the
connection.
The connector also contains the trigger1 connection for input or output of a trigger sig-
nal, and for working in trigger master-slave mode (optional), e.g. to synchronize sev-
eral sensor modules.
For information on how to assign the signals to the ports, see
the Trigger",
User Manual 1425.8663.02 ─ 05
on page 90.
Preparing for Use
R&S NRPM Tour
Chapter 7.8, "Configuring
13