Table of Contents
Advertisement
AD8450-EVALZ/ADP1972-EVALZ User Guide
EVALUATION BOARD SOFTWARE
INSTALLING THE SOFTWARE
The evaluation board software can be downloaded from the
AD8450, AD8451, and
ADP1972
Devices website at www.analog.com.
Install the software prior to connecting the SDP-S board to the
USB port of the PC to ensure that the SDP-S board is recognized
when it connects to the PC.
1.
Start the Windows® operating system and download the
software from the relevant product page on the Analog
Devices website at www.analog.com.
2.
Unzip the downloaded file. Run the setup.exe file.
3.
After installation is completed, plug the SDP-S board into
the PC using a USB cable, and power up the evaluation
board as described in the Powering the System section.
4.
Launch the software.
5.
When the software detects the evaluation board, proceed
through any dialog boxes that appear to finalize the
installation.
The default location for the software is C:\Program Files (x86)\
Analog Devices\AD8450-ADP1972_SystemDemo.
This location contains the executable software and support files.
INSTALLATION STEPS
Proceed through the installation, allowing the software and
drivers to be placed in the appropriate locations. Connect the
SDP-S board to the PC only after the software and drivers have
been installed.
There are two sequences to the software installation. The first
sequence installs the software related to the evaluation board, as
shown in Figure 3 to Figure 6.
Figure 3. Choose Folder Location (Default Folder Shown)
product pages on the Analog
Rev. 0 | Page 7 of 33
Figure 4. Click Next >> to Install Software
Figure 5. Bar Showing Installation Progress
Figure 6. Installation Complete, Click Next >> to Finish
UG-845
Advertisement
Table of Contents
Need help?
Do you have a question about the AD8450-EVALZ and is the answer not in the manual?