Set Material Types; Rate Calibration - Conair GB User Manual

The Keystroke sequence to set TYPES is:
Press: *
Press: 22222
Press: *
Press: 14
Press: CE repeatedly to select one of the four options.
When the selection you want is displayed, move on to NEXT component:
Press: *
REPEAT the "* CE" sequence for ALL components you use.
The * key will walk you through all components.
The CE key will change the TYPE for a component.
Components NOT CONNECTED, or NEVER USED, set to OFF.
When done:
Press: EXIT
Press: EXIT
After EXIT, if display says (NEED NAT) then you have specified an
ADDITIVE without specifying a NATURAL.
NOTE: FOUR dispense valve systems use components 1 through 4.
TWO dispense valve systems use 1 and 2.
SIX dispense valve systems use 1 through 4, then 7 and 8.
Panel front OUTLETS are always components 5 and 6.
Additional outlets are generally components 7 and 8.
+-----------------------------------------------------+
¦
¦ PROCEED TO:
¦
+-----------------------------------------------------+

SET MATERIAL TYPES

Display will say:
Display will say:
Display will say:
Display will say:
The "1" is the component (device) number.
This is component 1.
Display will say:
Display will say:
Display will say:
Display will say:

RATE CALIBRATION

Page 18
(PASSWORD)
(P x)
(INSTR --)
(1TY= OFF)
It will control Hopper 1.
(1TY= REG). (Regrind)
(1TY= NAT). (Natural)
(1TY= ADD). (Additive)
(1TY= OFF). (turned off)
(2TY= OFF)
(P x)
( x)
This is unacceptable.
NEXT PAGE
¦
¦
¦