Conair GB User Manual page 44

PASSWORD number for entering the PROGRAM mode.
is supplied with the number "22222" as the password number.
If you wish to restrict use of this mode to only yourself,
you may make up your own number and enter it here.
If you forget your password number, call us.
*82 Press (*,8,2) to produce a precision ratioing of a selected
Additive.
(P/R
an ADDITIVE will be displayed.
If precision rationing is selected, the specified additive
(selected by the *82 function) will dispense BEFORE the
Naturals, instead of after.
the selected additive dispense and are calculated to assure
the most exact percentage ratio for the selected component.
Because the Natural dispenses are larger, this method allows
for more exact ratioing of the one selected critical
component.
*83 Press (*,8,3) to select "Progressive Metering" option.
Progressive Metering allows for more accurate dispenses of
selected components.
by a few additional seconds.
In normal operation blenders target a dispense of the full
requested amount in one try.
generally will fall within acceptable upper and lower error
limits.
throughput rates while still achieving a level of accuracy
acceptable for most processors.
particular component is critical, or the process depends on
maintaining a tighter tolerance of this component, customers
may lengthen the blend cycle time slightly to achieve this
higher level of accuracy.
The *83 function is used to turn on the progressive metering
function for a selected component.
which will cause the dispense to occur in several
progressively smaller dispenses.
accurate dispense.
The first dispense targets only 85 percent (the default
percentage) of the full required amount.
weighing, each successive dispense targets 50 percent of the
remaining shortage.
reaches, or is within 1 percent of, the target.
manner the software "sneaks up" on the target, providing the
maximum achievable accuracy possible.
When a component is selected and turned ON, the
corresponding PT and RP parameters are set to PT 00085 and
RP 00001.
The keypad sequence:
Press *,8,3.
Use the "*" key to walk through all the components.
Press CE to toggle between (P/R OFF), (P/R
2), etc. Only those components already designated as
However, cycle time will be extended
Making the dispense in one try allows for high
This continues until the amount
Display will say (COL
Page 45
Natural dispenses occur after
This almost always works, and
When the accuracy of one
This sets parameters
This results in a more
After careful
OFF).
The system
We can help.
1),
In this