Printed Outputs; Monitoring System Accuracy; 54-Cycle Printout Information; Interrupting The 54 Cycle Printout - Conair GB User Manual

+---------------------------------------------------------------------+
¦
+---------------------------------------------------------------------+
The best way to monitor system accuracy is to connect a printer to the
printer port and turn the printer flag ON (KEYPAD section, *54).
printer will then automatically print full output information after
every cycle.
When the printer flag is ON, the controller will output a single
heading line at the top of each page and 4 information lines to the
printer at the end of each cycle.
cycle time.
Press:
Press:
Press:
Press:
Press:
Any common parallel printer that you would use with a small PC computer
may be used.
cable, (34 pin parallel Centronix connector to a DB25 IBM compatible
connector), available from us or at any computer store.
10 or 20 cycles of data can tell a lot about the performance of your
blender. The following will help you interpret the data.
A single cycle printout looks like this:
(dashes ---- added for clarity of spacing)
------------
**1 R 20.0**
* 11/10/97 * * 16:17:53 *
FINAL: DISP,%
RATE: GR/TIME 18224
1ST DISP,TIME
The TOP-OF-PAGE heading:
------------
**1 R 20.0**
Prints as a heading to each page, or once every 10 cycles.
as a heading over four columns of material.
PART III

MONITORING SYSTEM ACCURACY

*54 - CYCLE PRINTOUT INFORMATION
To turn the printer flag on:
* Display will say:
22222 Display will say:
*54 Display will say:
* Display will say:
EXIT Display will say:
EXIT Display will say:
Connect using a standard parallel printer connecting
INTERPRETING the *54 CYCLE PRINTOUT
------------
**2 N
RECIPE 0000
0.0 .0 1908.3
976 19993
0.0 00 1908.3
DEFINITION OF EACH LINE
------------
**2 N

- PRINTED OUTPUTS

This adds several seconds to each
(PASSWORD)
(P
(PRNT OFF)
(PRNT
(P
(
------------
100** **3 A 04.0**
**ID# 051**
77.6 4.06
488 12973 31232
469 77.6 1826
------------
100** **3 A 04.0**
Additional lines will
Page 74
The
x)
ON)
x)
x)
------------ ------
**4 A 00.0** TOTAL
**WO 000000* OPR000
0.0 .00 2000.1
10240 31232
0.0 00
------------ ------
**4 A 00.0** TOTAL
This serves
¦
9.9
22