Setting Key; Tag Key - Conair GB User Manual

dispenses take much less time.
in this manner.
This key is NOT FUNCTIONAL unless the 4th digit of the "FLG"
parameter is set to 1 (xxx1x).
MAINTENANCE section, PARAMETER TABLE, "FLG".
The shorter mixing time may be a problem.
FAST REPEAT cycles is kept as low as possible.
repeats may occur.
Press the FAST key to toggle the FAST flag ON of OFF.
set to (FAST OFF) the FAST mode will not operate.
to (FAST
followed by up to 4 FAST repeat dispenses.
This series of 4 dispenses is terminated as soon as the
sensor is covered, which indicates the blender has "caught
up".
by the required series of fast cycles to catch up again.
Press * to toggle between (FAST
Press EXIT, to exit.
When the FAST mode is in operation, the display ( FAST) will
flash intermittently.
SETTING: Press once and the current setting of component 1 is
(SET) displayed.
type, either R, (REGRIND); N, (NATURAL); or
xx.x is the current setting.
Press SET to step forward through all the settings.
Press * key to backup in the list.
NEW settings may be entered directly.
REGRIND and ADDITIVE settings are expressed as percents, up
to 99.9 percent.
weight).
NATURAL entries.
NATURAL, the value of it's setting has no meaning, except
that it must be set to some value to operate.
If you wish to restrict the entry of settings to the PROGRAM
mode only, (password required),
the _SE parameter for each component that you wish to "lock
out".
TAG: This key allows two pieces of information to be "tagged"
onto all data that is either printed or retrieved through
the computer port.
OPERATOR number.
This key is NOT FUNCTIONAL unless the 2nd digit of the "FLG"
parameter is set to 1 (x1xxx).
MAINTENANCE section, PARAMETER TABLE, "FLG".
ON) every normal calibrated dispense will be
The next cycle will then be a weighed cycle, followed
Display will say (1 X xx.x).
NATURAL is any number you wish (usually
It is used to establish RATIOS with all other
When only one material is designated as a
See MAINTENANCE SECTION, PARAMETERS, _SE parameter.
The items are WORK ORDER number and
Page 33
Throughput is easily doubled
To do this, see the SOFTWARE
So the number of
Up to 4
ON) and (FAST OFF).
X is material
A, (ADDITIVE).
you may do so by altering
To do this, see the SOFTWARE
When
When set