Dti; Kdf, Wdf; Ber; Roc - Conair GB User Manual

voltage to open the valve.
voltage to close the valve.
you must reverse the air lines to the flow control valve air cylinder.
Normal power-off position for the valve is closed.
prefer the valve open when all power is off.
reversed "power off" position.
apparent.
======================================================================

DTI

(probably no need to ever change this)
DTI is the maximum TIME allowed for the weighing bin to dump at
the end of the cycle.
detects no weight change occurring.
time that is allowed for the bin to empty.
limit according to the model and batch size.
======================================================================

KDF, WDF

(No change required)
KDF and WDF are the maximum acceptable variation in GRAMS between
two consecutive weight readings.
of time. Two readings are always taken and they must be within KDF
grams of each other to be accepted as valid.
continuously until two consecutive readings meet the criteria.
prevents a single accidental bump of the scale from causing a grossly
inaccurate reading.
for starting tare weight and component dispense weights.
======================================================================

BER

(change only if severe vibration causes problems)
BER is the BAILOUT ERROR weight.
accurate timing.
monitored during each dispense.
target weight during the dispense, then a BAILOUT occurs.
the dispense immediately just as if the end of the dispense time period
had been reached.
of the cycle. The dispense is checked and retries will occur if
required.
A bailout does not occur unless target weight is exceeded by the
weight given in the BAILOUT ERROR parameter.
prevent vibration from causing a false bailout during very small
dispenses. We set this parameter to a default of 00200 (20 grams or
200 grams). If vibration is causing false bailouts, then you may want
to set a higher value in this parameter.
If the BER parameter has a 1 in the last position, (BER 00201),
then a printout will occur of all cycle data anytime a bailout occurs
for any single component.
occurrences where dispenses significantly exceed target.
the same information that you see when the PRINT flag is on (*54).
printer must be connected.
======================================================================

ROC

(Allows for adding some ADDITIVE to one of the REGRIND
portions)
With this flag set the computer puts out a
For this reverse logic to work correctly,
With power on, no difference is
The software will close the bin earlier if it
One weight reading requires 1 second
KDF is used for load cell calibration weights, WDF
However, as a precaution, the weigh bin is constantly
If bin weight is found to exceed
This in no way effects the accuracy of the remainder
This is helpful if you want to be aware of
Page 54
This option allows this
This time determines the maximum
We set this maximum time
Readings are taken
Dispenses are controlled by very
This is primarily to
Some customers
This
This ends
This will be
A