Conair GB User Manual page 38

STAR FUNCTIONS available in this mode:
*02 This flag for EXTRUSION and YIELD control, and RATE display.
Press (*,0,2) to turn on Extrusion or Yield control.
The default display is (
Press * to toggle this flag to (
(YLD CTRL).
If you are using our EXTRUSION or YIELD control software to
control your extruder, refer to our EXTRUSION CONTROL
instruction booklet for complete information.
If you simply want to view throughput continuously on the
blender display, set this option to (
alter the display only.
will operate normally.
*03 Press (*,0,3) to allow four digit entry of settings in the
format (xx.xx).
accurate.
have a mixture of setting requirements, that is x.xx entry
requirements as well as the standard xx.x requirements.
Normally the XT parameter would be manually adjusted to
allow the decimal shift.
turned on, then all entries are in the format xx.xx.
software uses only the first three digits unless the first
digit is a zero, in which case the last three digits are
selected and the related XT parameter is set to 00010.
XT parameter for more information.
XXX) or (SET=XXXX).
*04 Press (*,0,4) to select from 4 standard software
configurations.
it is running FOUR software, then this option will do this
for you in one easy step.
Use the "*" key to toggle through all selections.
Select ( KEYPAD ) to exit without changing anything.
Select ( R,N,C,A) for system to operate like FOUR software.
Select ( N,N,C,A) to operate like FOUR software with the
Select ( N,N,N,A) to operate with three Naturals and an
Select ( R,N,N,A) to operate with Regrind, two Naturals,
Component 2 is ALWAYS a NATURAL, and is never assigned a
thumbwheel switch.
assigned to thumbwheel switches.
If ( R,N,C,A) is selected, component 2 is the ONLY natural
and is set to 100.
If ( N,N,C,A), ( N,N,N,A), or (R,N,N,A) is selected, the
first, third, and forth components are assigned to switches
3, 1, and 2 respectively.
adjusted automatically at the start of each cycle to a
In all other respects, the blender
This does not make the blender more
It does allow easier setup for customers that
If this four digit entry option is
Use * key to toggle.
If you want your unit to look and act like
"TWO NATURALS" flag on.
additive.
and an additive.
Components 1, 3, and 4 are always
Component 2 setting will be
Page 39
OFF).
RATE ), (EXT CTRL), or
RATE ).
Display will say (SET=
This will
The
See