This parameter times how long the weigh bin dump valve opens to
empty.
No change is required.
KDF 00002
Maximum variation in GRAMS between two consecutive weight
WDF 00002
readings for reading to be accepted. (x or x.x)
KDF controls sensitivity of weight readings during calibration of
load cells.
WDF controls the sensitivity of weight readings during normal
operation.
readings you may have to increase this number.
BER 00200
Excess GRAM weight before dispense is aborted.
This parameter controls sensitivity of the emergency "bailout"
routine that prevents overfilling of the weigh bin.
No change is required.
ROC 00000
These three parameters help control regrind usage.
ROV 00000
RHL 00000
ROC indicates the PERCENT of REGRIND that will be treated as
natural when COLOR and ADDITIVE dispenses are calculated.
This adds some color or additive to your regrind.
ROV is for closed loop fully automatic reprocessing of regrind
scrap. This parameter will detect when more regrind is being
produced than consumed, and override the current setting to
use a higher amount.
in your grinder.
RHL has effect only if level sensors are added to your unit to
detect material level in the regrind hopper.
sensors can alter regrind percent usage.
FUL 09000
Full batch weight, determined by weigh bin size.
MAX 13500
Maximum GRAM weight the software will target.
FUL is the target weight that is blended each cycle. Change only
for extremely fluffy or very heavy material.
MAX prevents overflowing of the weigh bin. It is reset
automatically if the FUL parameter is changed.
TH
01000
The highest and lowest acceptable TARE weights for
TL
00500
blend cycle to start. (full or tenth grams)
TL
prevents starting with the weigh bin out of place.
is required.
TH
prevents starting with a full weigh bin.
clumps of material hang up in the weigh bin.
PRT 00000
MINUTE interval between automatic print of TOTALS.
This parameter will cause your system to PRINT MATERIAL TOTALS
automatically.
DLY 00488
Delay before cycle start. (interrupts)
No change is required.
If excessive vibration interferes with weight
This helps prevent material backing up
A printer must be connected.
Page 49
These level
No change
Change TH only if