Layout Of The Material Hoppers; L A Y O U T O F T H E M A T E R I A L H O P P E R S; Mounting The Loaders; M O U N T I N G T H E L O A D E R S - Conair TrueBlend SB-4 User Manual

3 - 6 l I n s t a l l a t i o n

L a y o u t o f t h e M a t e r i a l H o p p e r s

4 position
Position 1
Position 3
Front door (mix chamber)
Position 1 & 2 = Main components
Position 3 & 6 = Main or additive
components
Position 4 &5 = Additive components

M o u n t i n g t h e L o a d e r s

1
Install the loaders/receivers onto the blender bins.
2
Supply power to the loader as needed. Refer to the manual the
came with your loader for specific instructions.
3
Supply compressed air to the loader as needed. Refer to the manual the came with
your loader for specific instructions.
4
Refer to the wiring diagrams that were shipped with your blender and loaders.
Position 2 Position 1 & 2 = Main components
Position 3 & 4 = Additive components
Controller location
Position 4
6 position
Position 1
Position 5
Position 2
Position 3
Position 4