Conair GB User Manual page 45

Use the "CE" key to toggle a component ON or OFF.
When ON, Display will say (C=ON
You may change the 85 by entering a different number.
Too low will just add time.
overshooting.
Press EXIT when done to save new settings.
*86 Press (*,8,6) to select a new "Back Door" password for your
software.
00009 to select one of nine new backdoor passwords.
us for the actual number.
of a backdoor password altogether, just enter a number from
1 to 9, and don't call us.
know the number.
your own selected regular password will work and as long as
you don't forget it, your ok.
Blenders are pre-programmed with two normal passwords;
(22222) is the default password for the PROGRAM mode,
(11111) is the default password for the MANUAL mode.
can alter these passwords to any 5 digit number, but you
must know the current PROGRAM password to change it.
some reason the password has been altered and you can not
remember it, we have a special "backdoor" password that will
let you in no matter what.
provide that password in this manual.
However, there is a problem.
factory obtains this password, then he will always have
access to the Program mode of the blender no matter what.
Now, with this star function, you have the option to select
from 10 different "backdoor" passwords.
"backdoor" password is known to the wrong person, you can
call us for a new one.
passwords to just anyone.
it is not that easy to obtain these numbers.
To activate a new "backdoor" password, you will enter a
number from 00000 to 00009 using this star function.
number activates a different password.
the current backdoor password, the one we have used for over
10 years.
know here in the office and they will supply a number from 1
to 9, and the associated new "backdoor" password.
After this new "backdoor" password is selected, you can
safely change the regular password to one only you know, and
use that in normal production.
the backdoor to get in.
password, and you also forget which backdoor password you
selected, then we will help you go through the entire list
to find the one that works.
*87 Press (*,8,7) to set flag for operation in a VOLUMETRIC
mode.
when done.
reset to OFF.
cells are completely ignored.
Display will say (BDP 00000).
But we still will, just in case.
For a new one, call us and talk with someone you
Use the * key to toggle flag ON or OFF.
When power is turned off this flag is always
With this flag ON (VOLUMETRIC mode), the load
Page 46
85).
Too high will cause occasional
If you just want to kill the use
Then no one in you plant will
For obvious reasons, we do not
You must call us.
If the wrong person in your
We will not give these backup
In fact, since only I know them,
entering 0 activates
No one will be able to use
If you forget your regular
Error correction and rate
Enter 00001 up to
Contact
Then
You
If for
If your current
each
Press EXIT