Connecting A Ptz Camera (M6100 Series); Connecting A Ptz Camera To The System - FLIR M6100 Series Instruction Manual

20 Connecting a PTZ Camera
(M6100 Series)
You can connect PTZ cameras (not included) to the system. You can use FLIR MPX or
analog PTZ cameras with the system. FLIR MPX PTZ cameras can accept PTZ com-
mands directly through the video cable. FLIR MPX PTZ cameras do not require wiring for
RS485.

20.1 Connecting a PTZ Camera to the System

To connect an MPX PTZ camera to the system:
• Connect the camera video cable to one of the Video IN ports on the system. If you have
an MPX PTZ camera, it will automatically be detected and can be controlled by the
DVR.
To connect an analog PTZ camera to the system:
1. Connect the RS485 wires for analog PTZ cameras to the AB ports on the rear panel of
the DVR. A is positive (+) and B is negative (-).
2. Right-click and click Main Menu. Enter the system user name (default: admin) and
your new, secure password if prompted.
3. Click >Setting>Pan/Tilt/Zoom.
4. Under Channel, select the channel your PTZ camera is connected to.
5. Under Control Mode, select Serial. Configure the following settings for your PTZ
camera:
NOTE
See the instruction manual for your PTZ camera for details on how to find the information below.
• Protocol: Select the camera's PTZ protocol (for example, Pelco P).
• Address: Enter your PTZ camera's address.
• Baud Rate: Enter the baud rate for your PTZ camera.
• Data Bits: Enter your PTZ camera's data bit setting.
• Stop Bit: Enter your PTZ camera's stop bit setting.
• Parity: Enter your PTZ camera's parity setting.
6. Click OK. You can now control your PTZ camera using the system.
#LX400100; r.46796/46796; en-US
158