Setting The Remote Control Address - FLIR M6100 Series Instruction Manual

7 Remote Control
7. Add: Configure remote control address. See below for details.
8. Rec: Press to open manual record menu.
9. Fn: Press to perform special functions in some menus.

7.1 Setting the Remote Control Address

If you have more than one system, you can set up your remote control to pair with a specif-
ic system.
To set the remote control address:
1. Right-click and click Main Menu. Enter the system user name (default: admin) and
your new, secure password.
2. Click and then click Setting>General>General.
3. Under Device No., enter the address number you would like to assign to the remote
control.
4. Click OK.
5. Using the remote control, press Add. Then enter the address number and press Enter.
NOTE
When entering the address number using the remote, make sure that you press three digits. A sin-
gle-digit number should be preceded by two zeros. A two-digit number should be preceded by one
zero. For example, if you entered 8 as the Device No., you have to press Add then 008 on the
remote.
#LX400100; r.46796/46796; en-US
14