Section 700 - Operation
•
FF3: Extension COS
Considerations
•
Forced DND override is available.
•
DND override function is available by Busy Override code.
DP to DTMF Signal Conversion
Description
Dial Pulse (DP) to Dual Tone Multifrequency (DTMF) Signal Conversion allows you to switch from
DP to DTMF signaling when using a DP trunk. For instance, if you dial into a Voice Mail system
using a DP trunk, you can switch to DTMF signaling to communicate with the Voice Mail system.
(The System can automatically change DP to DTMF tones based on the incoming and outgoing
timers).
Operation
To switch from DP to DTMF dialing:
1. Press the * key or the # key.
Hardware Requirements
•
N/A
Related Programming
•
FF1: DTMF
•
FF2: DP to DTMF (Outgoing)
•
FF2: DP to DTMF (Incoming)
Considerations
•
N/A
Flash
Description
You can send a flash signal on your telephone to release an outside line and then either automatically
reseize the same outside line or switch to extension dial tone status by pressing the FLASH key.
Trunk programming determines whether your phone reseizes the outside line or switches to extension
dial tone status.
576-50-700
Action
DBS 576 (USA) issued September 2001
Chapter 6. DSLT Features
Result
6-31