Stopping The Engine - Raider RD-T10 User Manual

37
фиг.19
Normal working angle.
Lower the machine gently so that the front of the machine is raised about 6 - 8 °.
For maximum milling effect, try holding the machine as shown at an angle while plowing the
soil.
Caution when working with mills when milling the soil:
• Do not use a rotor blade with a diameter less than 300 mm.
• Working with the cutter on a slope may cause the cutter to overturn.
• Do not allow the milling machine to operate with people who are not familiar with the
operating and safety instructions. This can lead to unwanted incidents.
• Wear suitable work shoes and clothing. Working with the machine with your feet open or
with your shoes open increases the risk of injury.
• Do not operate the cutter at night.
• Use two people for transportation.
• When the milling rotor is clogged with mud and stones, stop the engine immediately and
clean the rotor in a safe place. Make sure you wear gloves when cleaning the rotor. To
prevent damage or accident, check the cutter for any indications and warning signs each time
before using it.
CAUTION: DO NOT ALLOW THE MOTOR CULTIVATOR OPERATION ANGLE TO EXCEED
FOR 15 SHORT TIMES. THIS MAY BECOME FUEL TRANSFER IN LUBRICATION OIL,
DAMPED FLASHING AND HIGHLY LOADED PARTS OF ENGINE;

STOPPING THE ENGINE.

In unforeseen circumstances, turn the engine key to (pos. 1, fig. 20) "OFF" - (off)