Supermicro X13DSF-A User Manual page 43

Installing the PHM into the CPU Socket
1. Align peek nut (marked A) on the heatsink against threaded fastener (marked a) on the
CPU socket. Then align peek nuts (marked B, C, D) on the heatsink against threaded
fasteners (marked b, c, d) on the CPU socket, making sure that all peek nuts on the
heatsink are properly aligned with the correspondent threaded fasteners on the CPU
socket.
2. Once they are aligned, gently place the heatsink on top of the CPU socket, making sure
that each peek nut is properly attached to its corresponding threaded fastener.
A, B, C, D:
Peek Nut on the Heatsink
a, b, c, d:
Threaded Fastener on
the CPU socket
A, B, C, D:
Peek Nut on the Heatsink
a, b, c, d:
Threaded Fastener on the CPU socket
1U Heatsink (Top Side)
B
D
A
b
d
2U Heatsink (Top Side)
B
D
A
b
d
a
43
Chapter 2: Installation
C
c
a
C
c