Supermicro X13DSF-A User Manual page 146

Super X13DSF-A User's Manual
Strip Size:
Use this feature to select the RAID strip size. The options are 4KB, 8KB, 16KB, 32KB,
64KB, and 128KB. The available options are based on the setting of "RAID Level:" above.
Capacity (GB):
This feature allows you to enter the desired RAID capacity (in GB).
Create RAID Volume
Use this feature to create a RAID volume with the settings above. The options are Yes
and No.
Non-RAID Physical Disks:
This feature displays the information of non-RAID physical disk(s).
RAID Volumes:
This feature displays the information of RAID volumes that have been created earlier.
Intel(R) VROC tSATA Controller
Note 1: This section is based on your system features and related device(s) installed.
Note 2: This section is available when "SATA Mode Selection" is set to RAID.
Note 3: Refer to PCH SATA0 Configuration, PCH SATA1 Configuration, and PCH
SATA2 Configuration submenus in the BIOS Setup main menu to set "SATA Mode
Selection" (page
The following information is displayed.
•
Intel VROC tSATA driver version
Create RAID Volume
Name:
This feature allows you to enter the unique name of RAID volume.
RAID Level:
This feature allows you to select the RAID level. The options are RAID0(Stripe),
RAID1(Mirror), RAID5(Parity), and RAID10(RAID0+1).
Select Disks:
Select the desired RAID disks one by one by setting them to X. The options are (not
selected) and X (selected).
118).
146