Supermicro X13DSF-A User Manual page 119

SATA Device Type
Use this feature to specify if the device installed on the SATA port specified by the user
should be connected to a solid state drive or a hard disk drive. The options are Hard Disk
Drive and Solid State Drive.
Trusted Computing (Available when a TPM device is installed

and detected by the BIOS)
When a Trusted-Platform Module (TPM) device is detected by your system, the following
information is displayed:
•
TPM 2.0 Device Found
•
Firmware Version:
•
Vendor:
Security Device Support
Select Enable to enable BIOS support for onboard security devices, which are not displayed
in the OS. If this feature is set to Enable, TCG EFI protocol and INT1A interface will not be
available. The options are Disable and Enable.
*When "Security Device Support" is set to Enable, the following information is displayed:
•
Active PCR banks
•
Available PCR banks
SHA-1 PCR Bank (Available when "Security Device Support" is set to Enable)
Select Enabled to enable SHA-1 PCR Bank support to enhance system integrity and data
security. The options are Enabled and Disabled.
SHA256 PCR Bank (Available when "Security Device Support" is set to Enable)
Select Enabled to enable SHA256 PCR Bank support to enhance system integrity and data
security. The options are Enabled and Disabled.
Pending Operation (Available when "Security Device Support" is set to Enable)
Use this feature to schedule a TPM-related operation to be performed by a security (TPM)
device at the next system boot to enhance system data integrity. The options are None and
TPM Clear.
Note: Your system will reboot to carry out a pending TPM operation.
119
Chapter 4: UEFI BIOS