Table of Contents
Advertisement
3.5 Changing welding polarity
Welding polarity needs to changed for TIG welding. Also, some filler wires require changing the welding polarity. Check
the recommended welding polarity on the filler wire package.
Before handling electrical parts, ensure the welding device is disconnected from the mains.
Tools needed:
17 mm
Turn off the welding device and disconnect it from the mains.
1.
Open the wire feed cabinet hatch.
2.
Remove the protective rubber covers from the polarity terminals.
Use caution when handling electrical parts.
© Kemppi
49
Master M 205, 323
Operating manual - EN
1922130 / 2313
Advertisement
Table of Contents
