Table of Contents
Advertisement
2.
If needed, adjust the spool braking force by turning the spool hub fastener.
To install the filler wire:
1.
Release the filler wire end from the spool and cut off any deformed section so that the end is straight.
Ensure that the filler wire does not spill from the spool when it is released.
2.
File the tip of the filler wire smooth.
Sharp edges on the filler wire tip may damage the wire liner.
© Kemppi
20
Master M 205, 323
Operating manual - EN
1922130 / 2313
Advertisement
Table of Contents
