Analog Devices Advantiv EVAL-ADV7611EB1Z Evaluation Note page 31

Eval Note
out Set TX output <hdmi, dvi, us or forced>
port Select input port <a, b, c, d, e, f, g n(none) or t(auto)>
reset Reset system
run Resume software
stat Print system status
stop Stop software
vmute Video output mute <on or off>
edidmod Update RX EDID <on or off>
EDID will be modified before being written to the RX internal EDID.
Refer to REP_EVENT_TX_EDID_READY event processing in rep_notify.c
power Power <on or off>, <mode 0 or 1>
cecaudio send cec message about audio <opcode>, <directly addressed >,
<parameters>
xmtmode When no HDMI input connected (MXT mode), keep HDMI TX on or off
<on or off>
UART Terminal Settings
- Baud rate: 115200
- Data: 8-bit
- Parity: none
- Stop: 1-bit
- Flow control: none
Rev. PrA Page 31 of 31